REQUIRES  APPROX. 340 CFM AIR SUPPLY TO ACHIEVE 100 PSI.

LENGTH : 225mm

THIS IS AN ENTRY LEVEL NOZZLE , DESIGNED FOR SHORT TERM PROJECTS WHERE PRECISE COSTING IS REQUIRED, OR FOR THE OCCASIONAL PART TIME BLASTER. HELD IN NOZZLE HOLDER WITH LR1 RETAINING NUT.

IS MY NOZZLE WORN ? THERE ARE TWO SIMPLE TESTS TO CHECK....

1. INSERT A DRILL BIT THAT MATCHES THE ORIGINAL BORE SIZE OF THE NOZZLE. IF THERE IS ANY PLAY, IT'S TIME TO REPLACE.

2. LOOK DOWN THE LINER FOR ORANGE PEEL , RIPPLE EFFECT, OR OBVIOUS UNEVEN WEAR.
NB. FOR EVERY 10 psi OF AIR LOSS, THERE IS AN APPROX. 15% PRODUCTIVITY LOSS.

Nozzle air consumption chart - 24 kb